Skip to content

COVID-19 Updates for resources sector: fee relief | To report a serious incident to DEM, as required by Section 85(2) of the Petroleum and Geothermal Energy Act 2000, licensees should contact the serious incident reporting hotline on: (08) 8463 6666. For more information please visit the Compliance and Monitoring webpage | DEM-ERD has just released the first “Basin in a Box” data-package covering the Simpson and Pedirka Basins. The dataset is available via the “Data and Publications” page. Each package is a consolidated set of seismic and well data to facilitate new ventures and exploration assessments of frontier basins in South Australia. Data releases for other frontier basins will follow. | Changes to data submission requirements during COVID-19 restrictions. For further information see here.

The naming of petroleum wells must conform to the following convention (as agreed by APPEA and Geoscience Australia (formerly BMR) in 1996):

Naming of Wells

Under the Petroleum and Geothermal Energy Act 2000, the Department for Energy and Mining will not approve a well name if that name had already been used (drilled) in Australia.

*The onus is on the operator to check well names prior to sending in the well proposal to the Department for Energy and Mining.  The well name must be phonetically different to any previously used name.

The Geoscience Australia website has a database that operators can look at to see what  well names have already been used. Visit 

Vertical wells

The first well on a petroleum structure will be given a unique name (eg “Wildcat”) and be numbered as 1, subsequent wells on the same structure will be given the same name , but numbered sequentially.

Deviated wells

Single borehole Deviated wells will be named as above for vertical wells.

Multiple borehole wells will be named as follows:

The first borehole will be named as for a vertical well above (eg “Wildcat 1”)

Subsequent boreholes which are deviated from the same surface location to new objectives will be suffixed by “DW” (Deviated well) and numbered sequentially (eg “Wildcat 1 DW1”). If the additional borehole is the result of an unplanned mechanical difficulty (ie a sidetrack), the well will continue to considered a single vertical hole, but may use the ST suffix (eg “Wildcat 1 ST1”) for each sidetrack.

Relocated wells

If the well is prematurely abandoned due to mechanical difficulties, and is respudded a short distance away, it will be given the suffix A, B C etc. (eg Wildcat 1A).

Naming Structure

There is no space between deviation type and deviation number, and single spaces only.

Examples of this are below.

Big Lake 17 DW1
Big Lake 56 DW1
Moomba 31 ST1
Moomba 36 ST1
Albany 1A

Deepening of wells

If a well is drilled and the rig released, but is later re-entered and deepened (to address a new target), the original well will be named as for a conventional vertical hole (eg Wildcat 1), but the deepened interval will be named as for a deviated well (i.e. Wildcat 1 DW1). If the deepening is split into two operations due to technical reasons ( eg drilling suspended due to flooding, or part of the hole is drilled with a coiled tubing unit, and part with conventional rig), then only one well name will be assigned.

For more information, contact:

Principal Geologist
Geoscience and Exploration Branch
Energy Resources Division

+ 61 8 8429 2455